An automatic bilge pump that removes water without the need for a float switch. The electric bilge pump operates using an internal level sensor; when the water level reaches 2" (5cm), the bilge pump will automatically activate, removing water from the bilge. When the water level reaches 3/8" (0.9cm), the pump will turn off until the water level rises.

As bilges are not always clean and free from debris, if the level sensor becomes fouled by any debris or contaminated water, the pump's unique back-up feature will prevent the pump from entering a run-on condition, protecting the battery while maintaining automatic operation.

Key Features:

3rd wire allows for manual over-ride using a Seaflo switch panel, or it can activate an alarm or indicator lamp.
Check valve prevents water back flow.
Exclusive moisture tight seals.
Fully submersible and ignition protected.
High efficiency, low amp motor.
Includes removable discharge straight fitting.
Integral water level sensor controls the pump automatically.
Marine-grade silicon blocked, tin coated wiring.
Pump and switch are internally wired for easy installation.
Removable strainer and impeller area are accessible to clear debris.
Stainless-steel motor shaft.
Threaded discharge for easier installation and easier maintenance.

Technical Specifications:

Useful Links:

Read our bilge pump selection guide.